4-speed hole
3 posters
G3GM :: G3 :: General Discussion
Page 1 of 1
4-speed hole
Hey guys my last two parts for the trans swap are on their way the clutch rod firewall boot and a pilot pushing. Now i have a bench seat in my chevelle and i want to know if the hurst shifter will clear it and not interfere. And when i cut the hole for the shifter does it need to be directly in the middle of the hump or does it have to be to the left slightly? Thanks-Justin
JF74chevelle- G3GM Member
- Street Cred : 0
Re: 4-speed hole
couple things.
Did you get the 70-81 camaro firewall boot?
Put a magnet to the pilot bushing, if it sticks toss it out and.get a bronze one.
Yes the shifter is offset to the drivers side. Did you buy a 4 speed.hump for the floor? Or are you just going to screw the.boot down.
Hurst handles are interchangeable. Go to their site and find out which one you need. I don't think they mention bench seat. Only console.or.no console.
Did you get the 70-81 camaro firewall boot?
Put a magnet to the pilot bushing, if it sticks toss it out and.get a bronze one.
Yes the shifter is offset to the drivers side. Did you buy a 4 speed.hump for the floor? Or are you just going to screw the.boot down.
Hurst handles are interchangeable. Go to their site and find out which one you need. I don't think they mention bench seat. Only console.or.no console.
Joe73- Donating Member
- Street Cred : 83
Re: 4-speed hole
Use PB-656-HD from advance auto. I just replaced my pilot bushing a year ago and searched high and low for the non magnetic version.. Like Joe says, when you get it give it the magnet test just to be sure.
clanceman427- G3GM Enthusiast
- Street Cred : 16
Re: 4-speed hole
My Muncie.rebuild kit from jodys transmissions came with a non magnetic one. Great guy to deal with.
Joe73- Donating Member
- Street Cred : 83
Re: 4-speed hole
Also,.if.you go without the floor.hump you can get a "super boot" that will cover everything. Just search hurst super boot on eBay. They work well.
Joe73- Donating Member
- Street Cred : 83
G3GM :: G3 :: General Discussion
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|
Yesterday at 6:25 pm by 77camino
» 77 elco SS
Tue Mar 26, 2024 3:35 pm by Whisperer
» 3-g cars in Finland
Tue Mar 26, 2024 10:33 am by Finn Monte
» Stainless brake lines
Mon Mar 25, 2024 3:37 pm by Joe73
» New chassis for my 73
Sun Mar 24, 2024 8:39 pm by g3chevy / Mr Pontiac
» 1973 Chevelle SS, 350, 4spd. build
Fri Mar 22, 2024 3:21 pm by Joe73
» Rusty's progress Hood sorta Finalized and other Updates
Thu Mar 21, 2024 3:58 pm by Limey SE
» cluster metal trim
Thu Mar 21, 2024 9:23 am by Joe73
» Nos wheel well moldings
Wed Mar 20, 2024 2:33 pm by Limey SE
» Dash assembly for 73-77 Malibu/Monte/El Camino,etc.
Wed Mar 20, 2024 10:26 am by Limey SE