Bell housing help!!!!!
2 posters
G3GM :: G3 :: General Discussion
Page 1 of 1
Bell housing help!!!!!
Currently swapping in my muncie and i bought the wrong bell housing. I have a 10.5" clutch and flywheel 168 tooth. Will a 11" bellhousing fit or no? Swap has gone decently smooth so far except for the bell housing lol.
JF74chevelle- G3GM Member
- Street Cred : 0
Re: Bell housing help!!!!!
The 168 flywheel needs an 11 inch bellhousing. It will not fit in a 10.5 bellhousing. 10.5 clutch is fine as long as the flywheel has both, 11 and 10.5 inch clutch bolt patterns.
Joe73- Donating Member
- Street Cred : 80
G3GM :: G3 :: General Discussion
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|
Yesterday at 10:51 am by Mcarlo77
» 1973 Chevelle SS, 350, 4spd. build
Yesterday at 10:10 am by Joe73
» Five Decades?
Yesterday at 8:23 am by Iggy
» cluster metal trim
Sun Mar 17, 2024 8:02 pm by 76Chevelle2Tone
» 1977 Olds 442 in MN
Sun Mar 17, 2024 12:11 pm by g3chevy / Mr Pontiac
» Nos wheel well moldings
Sat Mar 16, 2024 9:58 pm by Limey SE
» Dual Dash Speaker Setup (Sent out and gone now)
Fri Mar 15, 2024 4:09 pm by fasrnur
» Rusty's progress Hood sorta Finalized and other Updates
Fri Mar 15, 2024 1:51 pm by bracketchev1221
» speedometer pointer bouncing
Wed Mar 13, 2024 10:27 pm by 76Chevelle2Tone
» WANTED 73-77 Chevelle 442 rear window louvers
Wed Mar 13, 2024 2:52 pm by Limey SE