How I improved my ITM 4 speed shifter
5 posters
G3GM :: G3 Tech :: Engine & Driveline
Page 1 of 1
How I improved my ITM 4 speed shifter
Been working on my clutch replacement/trans rebuild / shifter rebuild. I was able to rebuild my original ITM shifter with some improvements. It would allow the shifter to pass from 2nd to neutral wile leaving the trans still in 2nd (not good). I found that adding a .060" washer between the 1-2 detent arm and the spacer between 1-2 detent arm and the reverse detent arm solves that. Also tightens up the feel while allowing full factory function. Also shimmed the "pull up for reverse" spring 0.25" with a spacer and that made it better too. Also replaced the original main pivot tube, as it looked pretty beat up. McMaster Carr has alloy steel tubing by the foot fortthis. Now I know Hurst has a superior product but I'm staying true to stock factory while improving it:)
clanceman427- G3GM Enthusiast
- Street Cred : 16
Re: How I improved my ITM 4 speed shifter
Very NIce BUddy
___________________________________________
1977 Chevelle SE x2
One Mild original
one Wild NON original
Anthony
Limey SE- Management
- Street Cred : 97
Re: How I improved my ITM 4 speed shifter
Awesome job. A little tweaking goes a long way. Should feel real nice now.
Joe73- Donating Member
- Street Cred : 83
Re: How I improved my ITM 4 speed shifter
Hi I know this is an older post but I have a question. I have disassembled my shifter and am now trying to reassemble it. I am having a problem reinserting the cover plate that covers the back and curves around and covers the bottom also. What is the trick to getting this back in?? I have tried prying the main body apart but have had no luck! Thanks Dan.
vegadan- G3GM Newbie
- Street Cred : 0
Similar topics
» need help with 73 SS 4 speed shifter stick
» WTB: 1973 Chevelle SS 4 speed shifter stick
» Shifter Boot and Shifter likes factory
» WTB: 1973 Chevelle SS 4 speed shifter stick
» Shifter Boot and Shifter likes factory
G3GM :: G3 Tech :: Engine & Driveline
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|
Yesterday at 7:25 pm by 77camino
» 77 elco SS
Tue Mar 26, 2024 4:35 pm by Whisperer
» 3-g cars in Finland
Tue Mar 26, 2024 11:33 am by Finn Monte
» Stainless brake lines
Mon Mar 25, 2024 4:37 pm by Joe73
» New chassis for my 73
Sun Mar 24, 2024 9:39 pm by g3chevy / Mr Pontiac
» 1973 Chevelle SS, 350, 4spd. build
Fri Mar 22, 2024 4:21 pm by Joe73
» Rusty's progress Hood sorta Finalized and other Updates
Thu Mar 21, 2024 4:58 pm by Limey SE
» cluster metal trim
Thu Mar 21, 2024 10:23 am by Joe73
» Nos wheel well moldings
Wed Mar 20, 2024 3:33 pm by Limey SE
» Dash assembly for 73-77 Malibu/Monte/El Camino,etc.
Wed Mar 20, 2024 11:26 am by Limey SE