Is there anyone on the board who has access to a CNC or machine shop?
2 posters
G3GM :: G3 :: General Discussion
Page 1 of 1
Is there anyone on the board who has access to a CNC or machine shop?
I'm looking to have a small plate made up. Would like it made out of aluminum or steel. I can either send the piece to copy or send a tracing of it. Pic of what I need is below. It measures about 3" tall and about 2 3/4" wide. I'd like it to be about 5/16" thick.
Please Pm me if have a connection to do this. Thanks
Please Pm me if have a connection to do this. Thanks
Joe73- Donating Member
- Street Cred : 83
Re: Is there anyone on the board who has access to a CNC or machine shop?
You probably found closer from you but if you have no solution, i can probably do for you by laser cutting.
tropdeprojet- Donating Member
- Street Cred : 5
Re: Is there anyone on the board who has access to a CNC or machine shop?
I will keep that in mind. Thank you.
Joe73- Donating Member
- Street Cred : 83
G3GM :: G3 :: General Discussion
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|
Yesterday at 7:25 pm by 77camino
» 77 elco SS
Tue Mar 26, 2024 4:35 pm by Whisperer
» 3-g cars in Finland
Tue Mar 26, 2024 11:33 am by Finn Monte
» Stainless brake lines
Mon Mar 25, 2024 4:37 pm by Joe73
» New chassis for my 73
Sun Mar 24, 2024 9:39 pm by g3chevy / Mr Pontiac
» 1973 Chevelle SS, 350, 4spd. build
Fri Mar 22, 2024 4:21 pm by Joe73
» Rusty's progress Hood sorta Finalized and other Updates
Thu Mar 21, 2024 4:58 pm by Limey SE
» cluster metal trim
Thu Mar 21, 2024 10:23 am by Joe73
» Nos wheel well moldings
Wed Mar 20, 2024 3:33 pm by Limey SE
» Dash assembly for 73-77 Malibu/Monte/El Camino,etc.
Wed Mar 20, 2024 11:26 am by Limey SE