Rear control arms
4 posters
Page 1 of 1
Rear control arms
just wondering why the factory didnt completely box the control arms on the f41 suspension like they did on the earlier chevelles. Instead they got some bracket bolted to them that the sway bar mounts to. Anyone completely boxed the control arms? Thinking about doing so to strengthen them up when they get pulled to put in the poly bushings. Also does it use the same bushings as the earlier chevelles in the arms? Cause I was thinking of ordering a whole kit and installing the polys in the lowers only and in the lowers on my 70.
___________________________________________
www.cardomain.com/id/3115ultima
BlackChevelleSS- Management
- Street Cred : 20
Re: Rear control arms
Boxing them helps quite a bit. If you have any extra cash lying around, get some Edelbrocks. I like them. JB
JB2wheeler- G3GM Fanatic
- Street Cred : 28
Re: Rear control arms
ill probably just box in the stockers and install poly bushings, and put in a set of adjustable uppers.
___________________________________________
www.cardomain.com/id/3115ultima
BlackChevelleSS- Management
- Street Cred : 20
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|
Yesterday at 7:25 pm by 77camino
» 77 elco SS
Tue Mar 26, 2024 4:35 pm by Whisperer
» 3-g cars in Finland
Tue Mar 26, 2024 11:33 am by Finn Monte
» Stainless brake lines
Mon Mar 25, 2024 4:37 pm by Joe73
» New chassis for my 73
Sun Mar 24, 2024 9:39 pm by g3chevy / Mr Pontiac
» 1973 Chevelle SS, 350, 4spd. build
Fri Mar 22, 2024 4:21 pm by Joe73
» Rusty's progress Hood sorta Finalized and other Updates
Thu Mar 21, 2024 4:58 pm by Limey SE
» cluster metal trim
Thu Mar 21, 2024 10:23 am by Joe73
» Nos wheel well moldings
Wed Mar 20, 2024 3:33 pm by Limey SE
» Dash assembly for 73-77 Malibu/Monte/El Camino,etc.
Wed Mar 20, 2024 11:26 am by Limey SE