4 speed hump

G3GM :: G3 Tech :: Body

Go down

4 speed hump

Post by McCauley5983 on Sat Jul 30, 2011 1:25 pm

Where do I cut the hole for the shifter for a 4speed and does any one have pictures of hump installation
avatar
McCauley5983
G3GM Enthusiast
G3GM Enthusiast

Street Cred : 13

Back to top Go down

Re: 4 speed hump

Post by Limey SE on Sat Jul 30, 2011 1:50 pm


___________________________________________
avatar
Limey SE
Management
Management

Street Cred : 86

Back to top Go down

Re: 4 speed hump

Post by Landonus on Thu Feb 14, 2013 7:27 pm

Ever get your hump installed billy-ray?
avatar
Landonus
Donating Member
Donating Member

Street Cred : 5

Back to top Go down

Re: 4 speed hump

Post by McCauley5983 on Wed Mar 06, 2013 9:12 am

Ya it wasn't that bad I cut a small hole so the shifter would fit used the center console I had lying around to center the new sheet metal the welded it in more time consuming then anything
avatar
McCauley5983
G3GM Enthusiast
G3GM Enthusiast

Street Cred : 13

Back to top Go down

Re: 4 speed hump

Post by Dead Man on Wed Mar 06, 2013 11:40 am

avatar
Dead Man
G3GM Member
G3GM Member

Street Cred : 4

Back to top Go down

Re: 4 speed hump

Post by McCauley5983 on Wed Mar 06, 2013 11:17 pm

Would have been a nice resource when I did mine but nobody had measurments and that post hadn't been started yet
avatar
McCauley5983
G3GM Enthusiast
G3GM Enthusiast

Street Cred : 13

Back to top Go down

Re: 4 speed hump

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top


G3GM :: G3 Tech :: Body

 
Permissions in this forum:
You cannot reply to topics in this forum