valve covers (pay shipping)
2 posters
G3GM :: Classifieds :: Freebie Section
Page 1 of 1
valve covers (pay shipping)
if someone want to pay for shipping i can send you these alum. valve covers for small block chevys
i got them for my adjustments...they COULD be cleaned up but they are just spares for when you adjust roller rockers, you can cut the tops out of them so oil wont spill over the motor and you dont remove/install them 100 times for adjustment. i cleaned one to show they are good for that. just want em gone so if someone wants em PM your zip code ill et a shipping price and they are yours...
[img][/img]
[img][/img]
i got them for my adjustments...they COULD be cleaned up but they are just spares for when you adjust roller rockers, you can cut the tops out of them so oil wont spill over the motor and you dont remove/install them 100 times for adjustment. i cleaned one to show they are good for that. just want em gone so if someone wants em PM your zip code ill et a shipping price and they are yours...
[img][/img]
[img][/img]
coreys73chevelle- G3GM Senior Member
- Street Cred : 8
Re: valve covers (pay shipping)
afraid to tell you thems not alum them stamped steel (alum dont rust like that)
dragons_lair59- Donating Member
- Street Cred : 11
Re: valve covers (pay shipping)
whatever they are theyre free. rust isnt bad its gt a lot of dirt in them and the tops were going to gettin cut anyway, pretty much just a tool instead of a part
coreys73chevelle- G3GM Senior Member
- Street Cred : 8
Similar topics
» BBC Valve Covers
» WTB SBC Comp Cams Cast Valve Covers like in pic.
» Edelbrock Performer SBC manifold : Chevrolet cast aluminum finned valve covers
» WTB SBC Comp Cams Cast Valve Covers like in pic.
» Edelbrock Performer SBC manifold : Chevrolet cast aluminum finned valve covers
G3GM :: Classifieds :: Freebie Section
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|
Yesterday at 7:25 pm by 77camino
» 77 elco SS
Tue Mar 26, 2024 4:35 pm by Whisperer
» 3-g cars in Finland
Tue Mar 26, 2024 11:33 am by Finn Monte
» Stainless brake lines
Mon Mar 25, 2024 4:37 pm by Joe73
» New chassis for my 73
Sun Mar 24, 2024 9:39 pm by g3chevy / Mr Pontiac
» 1973 Chevelle SS, 350, 4spd. build
Fri Mar 22, 2024 4:21 pm by Joe73
» Rusty's progress Hood sorta Finalized and other Updates
Thu Mar 21, 2024 4:58 pm by Limey SE
» cluster metal trim
Thu Mar 21, 2024 10:23 am by Joe73
» Nos wheel well moldings
Wed Mar 20, 2024 3:33 pm by Limey SE
» Dash assembly for 73-77 Malibu/Monte/El Camino,etc.
Wed Mar 20, 2024 11:26 am by Limey SE