Experience with 400 SBC
5 posters
G3GM :: G3 :: General Discussion
Page 2 of 2
Page 2 of 2 • 1, 2
Re: Experience with 400 SBC
Yes that's how it is held in. I think you need the Gen VI timing chain to go with that install. Not positive.
bracketchev1221- G3GM Enthusiast
- Street Cred : 15
Re: Experience with 400 SBC
Yes you do have to use a Gen VI timing set.
Iggy- G3GM Member
- Street Cred : 15
Re: Experience with 400 SBC
I've been thinking about using a step nose cam in my 496, but have never done a conversion. When I left the machine shop the gen 6 blocks were just starting to come out, and usually it was a step nose cam in a 6 block. The Mk IV blocks were getting the standard cam with a button.
bracketchev1221- G3GM Enthusiast
- Street Cred : 15
Page 2 of 2 • 1, 2
G3GM :: G3 :: General Discussion
Page 2 of 2
Permissions in this forum:
You cannot reply to topics in this forum
|
|
» 2" rear lowering springs
» 3-g cars in Finland
» Direct fit radiator
» hot rod article
» Engine Noise - Need Some Help
» Rusty's progress Stripe tracing for a Hopefull completion
» 882 Heads from 74 Corvette
» 1 inch rear sway bars Impala SS etc
» Fuel gauge