FOR A BUDDY.
G3GM :: G3 Tech :: Engine & Driveline
Page 1 of 1 • Share •
FOR A BUDDY.
A buddy of mine needs to know the timing for a 67 Pontiac 400.
Anyone know?
Anyone know?
74MonteCarlo- G3GM Fanatic

- Street Cred: 16
Re: FOR A BUDDY.
where it runs the best and doesnt detonate.... 

___________________________________________
www.cardomain.com/id/3115ultima


BlackChevelleSS- G3GM Senior Member

- Street Cred: 13
Re: FOR A BUDDY.
Timing should be 10 to 12 degree's before top dead center (with distributor's vacuum advance plugged) and 1000 to 1200 rpm in neutral (800 to 900 rpm in gear). There should be a sticker in the engine compartment to give precise spec's for your car. The dwell listed above sounds a little high but may be correct. I know the point gap should be 0.019in.
Limey SE- Management

- Street Cred: 60
Re: FOR A BUDDY.
just checked my source again and it says that was for a 69 400....( i didnt see you said 67 ) It should be the same if not let me know74MonteCarlo wrote:Thanks buddy. I'll let him know.
Limey SE- Management

- Street Cred: 60
Re: FOR A BUDDY.
Its not even for his car. Its for a buddy of his. LOL! Thanks again! Lol.
74MonteCarlo- G3GM Fanatic

- Street Cred: 16
Re: FOR A BUDDY.
BlackChevelleSS wrote:where it runs the best and doesnt detonate....
Smartass!
True enough though.
___________________________________________
DISCLAIMER:THE ABOVE COMMENT IS NOT POINTED SPECIFICALLY AT ONE PERSON!!! Rago reserves all rights to delete, alter, cancel, or otherwise modify any comments that may make some people's panties in a bunch at any time without notice or liability. All comments subject to change depending on mood or sobriety status. Copyright - Rago 2010


The Dude- Management

- Street Cred: 48
Similar topics» I don't like to sled alone - need a ride buddy
» My little scuba dive buddy/stang boy came into this world yesterday..:)
» For Sale: Buddy Club P1 Racing Alloy wheels & Tyres
» 51 years when Buddy Holly toured Australia
» Check out my buddy's T-Bolt Clone...............
» My little scuba dive buddy/stang boy came into this world yesterday..:)
» For Sale: Buddy Club P1 Racing Alloy wheels & Tyres
» 51 years when Buddy Holly toured Australia
» Check out my buddy's T-Bolt Clone...............
G3GM :: G3 Tech :: Engine & Driveline
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum





» Engine Mount help
» Boss's 65 hemi coronet for sale @ mecum indy.. could be yours Limey
» 1973 CHEVELLE SS 454
» 1976 Malibu Classic Olympic Edition
» Parts 73-77 for sale ( chevelle elcamino and S-3)
» Quarter windows
» Lowrider Regal and Monte
» The new baby!
» Any Bidders out there?????