printed board

[jared76]

Hey is there a place to get the printed board on the back of the roundgauge dash? I need one.

[bigredlaguna]

I don't think they are reproduced for these cars, maybe someone here has a spare.

[77mali]

There are believe it or not but you have to confirm the number on your board will match the aftermarket one.

http://www.ecklerschevelle.com/electrical/dash-and-console/printed-circuits.html

I know this because I need one too...LOL

[bigredlaguna]

Awesome! This source needs to be stickied.

[77mali]

There are a few other sites too that have them one is an el-camino site (wish I could remember which one) & i think OPGI had them also. Eckler's is the cheapest I've found so far.

[jared76]

what about the connector that goes on the board? the 11 P/N 651129 connector?

[77mali]

That's just the screw in light bulb base/hold down.

The P/N you want to match is on the clock side of the board. They reference these #'s in the descriptions on the website.

[1973 454 MONTE]

http://www.ebay.com/itm/8016692866?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649

[pila]

If anyone ever needs a printed circuit for a dash with idiot lights, I have a spare from a '75, which when compared to the '77 I used, is the same.

I have quite a few misc small parts left over from mid-70s Elco & Malibu. I'll have to make a list of this stuff......

[Sponsored content]