Is there anyone on the board who has access to a CNC or machine shop?
2 posters
G3GM :: G3 :: General Discussion
Page 1 of 1
Is there anyone on the board who has access to a CNC or machine shop?
I'm looking to have a small plate made up. Would like it made out of aluminum or steel. I can either send the piece to copy or send a tracing of it. Pic of what I need is below. It measures about 3" tall and about 2 3/4" wide. I'd like it to be about 5/16" thick.
Please Pm me if have a connection to do this. Thanks

Please Pm me if have a connection to do this. Thanks

Joe73- Donating Member
- Street Cred : 80
Re: Is there anyone on the board who has access to a CNC or machine shop?
You probably found closer from you but if you have no solution, i can probably do for you by laser cutting.
tropdeprojet- Donating Member
- Street Cred : 5
Re: Is there anyone on the board who has access to a CNC or machine shop?
I will keep that in mind. Thank you.
Joe73- Donating Member
- Street Cred : 80
G3GM :: G3 :: General Discussion
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|
» G3GM IS ON THE MAP!!!
» Not one of ours...had to share... VegaCamino
» AC compressor belt tension
» 1977 Chevelle SE Interior Updates July 2nd
» 73 Cutlass 4-speed
» 4th of July
» '74 "SS" - Los Angeles
» Power Tour 2022 and a G3 resident in Some of it
» LS swap