New guy here from Florida

Page 11 of 11 Previous  1, 2, 3 ... 9, 10, 11

Go down

Re: New guy here from Florida

Post by thepossumface on Wed Dec 11, 2013 12:46 pm

thanks will do, now i wanna find the laguna nose and keep the laguna look to it, sucks there isnt any down here :/
avatar
thepossumface
G3GM Member
G3GM Member

Street Cred : 1

Back to top Go down

Re: New guy here from Florida

Post by thepossumface on Wed Jan 01, 2014 4:12 pm

Well most of the car is stripped and so forth of interior except my seats which are going to be sold here in the next few weeks, gonna sand blast the whole inside weld the sheet metal to the floors so no more rust holes, and start on redoing the interior while we wait on the motor to be fixed im debating on to fix what I have in there or buy a new 454 motor and put in fuel injection on it,
any thoughts or ideas if anyone else has done a Efi swap? im prob going to rip all the wiring out and put a painless wire harness in it and redo all the wires so I know this isnt half assed
avatar
thepossumface
G3GM Member
G3GM Member

Street Cred : 1

Back to top Go down

Re: New guy here from Florida

Post by WyldeBill66 on Wed Jan 01, 2014 4:41 pm

There are a few nice EFI systems out there, but they are a bit pricey for me. I think they are around $2000 on the average. Holley makes a good one from what I've read about tests on it. I've thought about doing the same with the wiring on my 75 Chevelle too. Underdash is a bit messy with some cut wires. Good luck on getting it squared away, and I look forward to seeing pictures of your progress. Maybe you should make a build thread.

Bill

WyldeBill66
G3GM Member
G3GM Member

Street Cred : 3

Back to top Go down

Re: New guy here from Florida

Post by thepossumface on Wed Jan 01, 2014 9:43 pm

i think i will do that once i get a computer and camera up again, ive read about the holly efi thing in a article one day and sounds very good to have but right now im seeing on what i can work with and figure out the wiring out after words, i love my carb's but id like to see what the car will push with the EFI system and then later upgrade to a weland super charger. but thats just what I would like to do in the future with it.
avatar
thepossumface
G3GM Member
G3GM Member

Street Cred : 1

Back to top Go down

Re: New guy here from Florida

Post by thepossumface on Sun Jan 05, 2014 2:00 pm

Can anyone tell me how much the rear bumber would cost? i got a guy who wants it but idk what they would go for, maybe 100?
avatar
thepossumface
G3GM Member
G3GM Member

Street Cred : 1

Back to top Go down

Re: New guy here from Florida

Post by Mcarlo77 on Sun Jan 05, 2014 3:04 pm

That's the going rate from the salvage yards around me (except the Pick 'N Pulls...where they're considerably cheaper).
avatar
Mcarlo77
Donating Member
Donating Member

Street Cred : 66

Back to top Go down

Re: New guy here from Florida

Post by dynchel on Sun Jan 05, 2014 3:42 pm

Probably about $150.00. More or less depending on condition.
avatar
dynchel
Donating Member
Donating Member

Street Cred : 40

Back to top Go down

Re: New guy here from Florida

Post by Sponsored content


Sponsored content


Back to top Go down

Page 11 of 11 Previous  1, 2, 3 ... 9, 10, 11

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum