Gear Selector Wire
4 posters
Gear Selector Wire
by Hawk03 Thu May 21, 2020 9:55 am
The wire for the gauge selector has rubbed a grove into the plastic on the cluster and doesn't seem to operate that smoothly. Any ideas on how to allow the wire to move more freely? I thought about adding some epoxy in the groves but with my luck, I'd somehow epoxy the wire to it as well.
Hawk03- G3GM Enthusiast
- Street Cred : 18
Re: Gear Selector Wire
by 76 Malibu Sat May 23, 2020 1:41 pm
Other than epoxy, maybe filling it with a plastic weld kit? If it's ABS plastic you could try to fill with ABS cement and sand when it hardens.
Last edited by 76 Malibu on Sat May 23, 2020 4:30 pm; edited 1 time in total
76 Malibu- G3GM Member
- Street Cred : 1
Re: Gear Selector Wire
by fasrnur Sat May 23, 2020 1:47 pm
Maybe file or sand it lightly to smooth out the grove?
fasrnur- G3GM Enthusiast
- Street Cred : 9
Re: Gear Selector Wire
by g3chevy / Mr Pontiac Sat May 23, 2020 2:40 pm
I agree, file it or sand it just enough to get out the sharp edges. Then put some graphite powder on it to keep it moving freely.
g3chevy / Mr Pontiac- Donating Member
- Street Cred : 32
Re: Gear Selector Wire
by Hawk03 Sat May 23, 2020 4:21 pm
Sanding was a good idea but my patience wouldn't tolerate it, lol. I ended up adding epoxy to it and it seems better.
Hawk03- G3GM Enthusiast
- Street Cred : 18
Similar topicsPermissions in this forum:
You cannot reply to topics in this forum
» Spotted
» A little ink -
» 1975 Hurst Olds W-30 Build
» Rusty's progress UPPER LOWER trailing arms and coils in
» 76 Laguna parked in 2002
» Harmonic Balancer Install Tool
» Pre Bent Fuel Line
» 77 LEMANS
» Monte Carlo -75