1973 Grand Prix 4 speed conversion
3 posters
G3GM :: G3 Tech :: Engine & Driveline
Page 1 of 1
1973 Grand Prix 4 speed conversion
I am new to this site. Would like to know if there is an aftermarket conversion kit to install an ST 10 4speed in a 1973 Grand Prix. Looking for the pedals, Zbar linkage and crossmember. I have the trans, bellhousing, clutch, flywheel etc. The center console is not needed. This vehicle currently has no engine or trans so I would be installing a Pontiac 400 engine along with the Borg Warner 4 speed. Thanks for any information and comment.
Monk- G3GM Newbie
- Street Cred : 0
Re: 1973 Grand Prix 4 speed conversion
As far as I know, the crossmembers are all the same, you just have to move them to a different set of holes. For all the other parts, there is a sticky up top of this section with a link to all the parts.
bracketchev1221- G3GM Enthusiast
- Street Cred : 15
Re: 1973 Grand Prix 4 speed conversion
Thanks for the replys. Much appreciated.
Monk- G3GM Newbie
- Street Cred : 0
G3GM :: G3 Tech :: Engine & Driveline
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|
» Rusty's progress Carpet Chevk now onto floor replacement
» PARTS NEED TO GO FOR OUR MOVE I DONT WANNA TAKE WITH
» Need driver side bucket seat 73 Laguna
» Laguna NOSE
» Virtual Ink from this weekend
» 1973 Chevelle SS Station Wagon
» Elcofest 2023
» Wanted drip rails for 1975 four-door Chevelle Malibu-Thanks!
» Parts please