Cam Bearing Tool
3 posters
G3GM :: G3 Tech :: Engine & Driveline
Page 1 of 1
Cam Bearing Tool
I just bought a cam bearing install/remove tool, off ebay. Here is the link http://www.ebay.com/itm/380465586090?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649
I have to say its pretty well made. I just removed my cam bearings in just a couple of minutes. I know it does small block chevys and I believe V6's as well. No mention of doing other brand engines. No instructions were included with the tool but its real simple to figure out. There's also youtube videos that show you have to do it.
So if anyone is interested in doing their own bearings, this tool is worth it. Especially for only $34 delivered.
Ant7377, your more than welcome to borrow it anytime.
I have to say its pretty well made. I just removed my cam bearings in just a couple of minutes. I know it does small block chevys and I believe V6's as well. No mention of doing other brand engines. No instructions were included with the tool but its real simple to figure out. There's also youtube videos that show you have to do it.
So if anyone is interested in doing their own bearings, this tool is worth it. Especially for only $34 delivered.
Ant7377, your more than welcome to borrow it anytime.
Joe73- Donating Member
- Street Cred : 83
Re: Cam Bearing Tool
Hey Joe ! That was a decent price.
Over the years I made my own parts for mine, to do Pontiacs, Cadillacs, Hemi Chryslers etc, to fit the original tool.
Over the years I made my own parts for mine, to do Pontiacs, Cadillacs, Hemi Chryslers etc, to fit the original tool.
pila- Donating Member
- Street Cred : 43
Re: Cam Bearing Tool
Cool. Good tool to have. I'm looking for a bore gauge if anyone is selling one cheap. I'd even take a harbor freight one but they dont make them anymore.
Joe73- Donating Member
- Street Cred : 83
Similar topics
» Tool boxes rolling tool chests snap on
» Harmonic Balancer Install Tool
» valve seals what tool to use
» Harmonic Balancer Install Tool
» valve seals what tool to use
G3GM :: G3 Tech :: Engine & Driveline
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|
Today at 1:02 pm by TW Monte
» Rusty's progress Carpet Chevk now onto floor replacement
Today at 10:51 am by Limey SE
» PARTS NEED TO GO FOR OUR MOVE I DONT WANNA TAKE WITH
Today at 10:34 am by Limey SE
» Need driver side bucket seat 73 Laguna
Yesterday at 2:05 pm by Limey SE
» Laguna NOSE
Mon Jul 22, 2024 12:58 pm by Iggy
» Virtual Ink from this weekend
Mon Jul 22, 2024 8:43 am by Keith Seymore
» 1973 Chevelle SS Station Wagon
Sun Jul 21, 2024 12:14 pm by g3chevy / Mr Pontiac
» Elcofest 2023
Sat Jul 20, 2024 10:14 am by 77camino
» Wanted drip rails for 1975 four-door Chevelle Malibu-Thanks!
Wed Jul 17, 2024 8:02 pm by 76Chevelle2Tone
» Parts please
Tue Jul 16, 2024 10:34 am by bracketchev1221