What are the two threaded "bungs" in the driveshaft tunnel for?
3 posters
What are the two threaded "bungs" in the driveshaft tunnel for?
by jurgenday Sun Apr 14, 2013 5:49 pm
This is on a '76 Guna S-3
Any ideas?
Thanks
Any ideas?
Thanks
jurgenday- G3GM Member
- Street Cred : 1
Re: What are the two threaded "bungs" in the driveshaft tunnel for?
by Joe73 Sun Apr 14, 2013 5:53 pm
If they're about rearward of the tranny crossmember, they are for the seatbelts.
Joe73- Donating Member
- Street Cred : 80
Re: What are the two threaded "bungs" in the driveshaft tunnel for?
by jurgenday Sun Apr 14, 2013 5:55 pm
Damn im dumb...................didnt even think about that.......................maybe i should look a little harder before i ask.
Thanks!
Thanks!
jurgenday- G3GM Member
- Street Cred : 1
Re: What are the two threaded "bungs" in the driveshaft tunnel for?
by pila Sun Apr 14, 2013 6:09 pm
Welcome to the DUH ! club ! Been there, done that 
pila- Donating Member
- Street Cred : 43
Sponsored content
Similar topics» Temps inside cold frame/hoop tunnel
» cover is made, trellis is up
» Formentor (cycle ride to, from CSV) Part 2
» Natural Tunnel State Park, VA - update
» making a window in the low tunnel hoop house
» cover is made, trellis is up
» Formentor (cycle ride to, from CSV) Part 2
» Natural Tunnel State Park, VA - update
» making a window in the low tunnel hoop house
Permissions in this forum:
You cannot reply to topics in this forum|
|
|
» Monte Carlo -75
» looking for 73-76 Laguna dash logo
» ride of week
» BBC Brackets and Pulleys
» Rear Brakes
» Is it really restored? [long post]
» New Project 2017 Silverado
» logos
» 1978 Silverado