G3GM
Would you like to react to this message? Create an account in a few clicks or log in to continue.

G3GM 1973 to 1977 A-bodys. Chevelles, Monte Carlos, El Caminos, Laguna, 442, Cutlass, Malibu, GTO, LeMans, Century, Regal, Grand Am, Grand Prix, Sprint, Gran Sport, Can Am, Hurst-olds, and other 73-77 A-bodies


HorsePower's Port and Polish for Power How-To

2 posters

G3GM :: G3 Tech :: Engine & Driveline

Go down

HorsePower's Port and Polish for Power How-To Empty HorsePower's Port and Polish for Power How-To

Post by Limey SE Tue Jul 26, 2011 4:01 pm

also shows how to make a crankcase evap kit to bolt into your longtube headers


http://www.powerblocktv.com/video/?ep_show=HP

___________________________________________
1977 Chevelle SE x2
One Mild original
one Wild NON original
Anthony
Limey SE
Limey SE
Management
Management

Street Cred : 97

Back to top Go down

HorsePower's Port and Polish for Power How-To Empty Re: HorsePower's Port and Polish for Power How-To

Post by oldstofty Tue Jul 26, 2011 4:50 pm

I have Evacuation running from my valve covers to my collectors. Uses a 3/4 inch pipethread bung welded into the collector. But I have been reading up and they say that if you run mufflers its virtually impossible to create vacuum there. so I dont really know if its doing a whole lot
oldstofty
oldstofty
G3GM Member
G3GM Member

Street Cred : 7

Back to top Go down

Back to top

- Similar topics

G3GM :: G3 Tech :: Engine & Driveline

 
Permissions in this forum:
You cannot reply to topics in this forum